|
|
Cruiser
Posts: 181
Henlow, Bedfordshire, England | Bought my Vision a stand after seeing them at our national bike show, I was a bit concerned but the business owner assured me they take a Gold Wing. No worries though they are fantastic, keeps the bike upright in the garage and will be a great help when cleaning it and easy enough to push the bike back out again.
Edited by uknessie 2009-12-13 1:31 PM
(P1010712.jpg)
(P1010714.jpg)
(P1010715.jpg)
(P1010724.jpg)
(P1010721.jpg)
Attachments
----------------
 P1010712.jpg (40KB - 13 downloads)
P1010714.jpg (69KB - 7 downloads)
P1010715.jpg (69KB - 2 downloads)
P1010724.jpg (67KB - 3 downloads)
P1010721.jpg (66KB - 3 downloads)
|
|
| |
|
Visionary
Posts: 3204
Memphis | Very nice uknessie. I made the mistake of buying a Vision centerstand and wanted it remove within 20 minutes of the install. Big $300 mistake on my part. A set-up like that would be nice to find here in the States. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | sf what's wrong w/the CS? |
|
| |
|
Visionary
Posts: 3204
Memphis | Will start a new thread. Don't want to distract from this one. |
|
| |
|
Cruiser
Posts: 181
Henlow, Bedfordshire, England | They are made in the UK and retail for less than £100 ($170). would have though someone there must make one but it wouldnt cost a fortune to ship either. Be less than the $300 center stand. |
|
| |
|
Visionary
Posts: 8144
New Bohemia, VA | uk, thanks, that is nice, very handy. |
|
| |
|
Iron Butt
Posts: 810
| I see these Condor wheel chocks at the bike shows all the time. They make free-standing ones and ones that switch between free standing and trailer/lift chocks. I almost bought one a week ago a the IMS show.
HTH, Tim
www.condor-lift.com www.condor-lift.com/product.asp?ItemID=1001 
Edited by TimS 2009-12-13 7:33 PM
|
|
| |
|
Cruiser
Posts: 172
Prescott, Az | I bought a Condor Chock when I had a Honda VTX. It was fine. Now I have the Vision and I adjusted the chock to fit the Dunlop and I had a tipover! I used the chock on the garage floor and appently I did not center the Vision exactly in the chock ie: the rear wheel and the front wheel were slightly off although all looked and felt OK as I rode into it. I got off the Vision, turned around and heard a crash. The bike with the chock still attached fell over on the left side. Minimal damage to the bike but a row of shelves broke the fall. I think if the fall was not broken, the Vision MIGHT have gove over past the tipovers and right onto its side. I had to get a neighbor to help right the bike. I no longer trust the chock detached from the trailer. Just something to think about if you decide to use the Condor. The cheapie from Harbor freight has a longer base and it probably would hold the Vision better. |
|
| |
|
Fountain Inn, SC United States | Great info! I've moved this to our Product Review forum. Thanks! |
|
| |
Bike Stand
