|
|
Cruiser
Posts: 175
Hinton, Iowa | My Cruise just quit working and was wondering if anyone might have some idea why. My dealer thought it might be in the switch but I doubt it because the light on the switch comes on (red One) Then when I set the cruise the Green light on the dash lights up when you set it, but it won't hold the speed. Any ideas would help
Also I noticed this morning that the middle right side tail light is out and thought I heard that the lights and the cruise were tied together. A friend of mine tried to put L.E.D. tail light bulbs on his 2012 Vision and the cruise wouldn't work til he change the bulbs back. Thanks in advance. Ride Safe, Mike |
|
| |
|
Visionary
Posts: 2300
Georgia, west of Atlanta | Never noticed that but I had my 08 apart for paint and powdercoat. When it went back together I think one of the headlights was out and the cruise didn't work. It was a fuse.............Both working fine since. |
|
| |
|
Visionary
Posts: 4278
| Your idle gable might be to tight. Put some slack in it and see what happens.
Get out your meter and see if power is the right places. |
|
| |
|
Cruiser
Posts: 192
Republic of Tejas | Mike, if your power led is lit when you turn the cruise on the fix may be to look down the right side of the console anout 8 inches down, you'll see the top of a T shaped plug with two wires running into the top of it. Reach down and push the plug back into the socket so that it is fully seated. |
|
| |
|
Tourer
Posts: 576
, IA | Won't work under 25 mph. |
|
| |
|
Tourer
Posts: 500
| Similiar issue with my 2011..Found cable from control to throttle had popped out of the black plastic holder on the right side under the tank next to the cheese wedge...Put back in with small knife edge, (all that was handy) and it has worked fine ever since....May be your fix?? |
|
| |
|
Tourer
Posts: 599
New Mexico | *** Never Mind, you got it figured out ***
Edited by Boots 2012-12-04 12:17 PM
|
|
| |
|
Cruiser
Posts: 175
Hinton, Iowa | opas ride - 2012-12-03 8:39 PM
Similiar issue with my 2011..Found cable from control to throttle had popped out of the black plastic holder on the right side under the tank next to the cheese wedge...Put back in with small knife edge, (all that was handy) and it has worked fine ever since....May be your fix??Thanks,David Fixed mine this morning. It was the cable that popped out like you said. Thanks all for your input. Ride Safe,Mike |
|
| |
|
Cruiser
Posts: 244
| My 09 quick working after seating in the hot sun with a cover over it. Simptoms were the on lite comes on but won't work, fuse blown becasuse of PINCHED wire in the dash assemble |
|
| |
|
Iron Butt
Posts: 880
Orlando, FL | Also, there are issues if your bike gets really wet. It's in a thread here somewhere. Happened to me after riding in pouring rain for 2 days. Bike dried out and cruise worked again. Never did the fix in case it happens again. Just being lazy! LOL
|
|
| |
Cruise quit working on13 Vision? WTF
